Generic placeholder image

Recent Innovations in Chemical Engineering

Editor-in-Chief

ISSN (Print): 2405-5204
ISSN (Online): 2405-5212

Research Article

Physical and Mechanical Properties of Biodegradable Plastic Produced From Jackfruit (Artocarpus heterophyllus) Seed and Sago Starch Blend

Author(s): Fairuzdzah Ahmad Lothfy*, Mohd Suhazree Mohd Azhar, Nur Sha’adah Zainuddin and Junaidah Md Sani

Volume 13, Issue 5, 2020

Page: [398 - 406] Pages: 9

DOI: 10.2174/2405520413999200728144906

Price: $65

Abstract

Objective: Jackfruit (Artocarpus heterophyllus) is a tropical fruit that has high amylose content in its seeds similar to sago starch. Thus, jackfruit seeds and sago are suitable raw materials for the production of biodegradable plastic (BGP). The objective of this research is to investigate the physical and mechanical properties of BGP produced from the blend of jackfruit seed and sago starch.

Methods: The BGP was prepared by mixing different ratios of the jackfruit seed flour to the sago flour in distilled water with the addition of 0.1 M hydrochloric acid (HCl). The mixture was stirred and heated at 80oC and later mixed with glycerol. The mixture was neutralized with 0.1 M sodium hydroxide (NaOH) and was cast by using the casting plate technique.

Results: The results showed that the optimum tensile strength was obtained at 2.06 MPa. at the blend ratio of 7:3. The maximum absorption rate of water ranged from 32 % to 34 % occurred at the blend ratio of 1:9 while the lowest absorption rate ranged from 21% to 26% occurred at the blend ratio of 5:5. The degradability of BGP was indicated by decreasing the FT-IR spectra peaks intensity and broadening of the bandwidth due to the degradation of starch in the BGP.

Conclusion: The blend ratio of 10:0 showed the highest degradability rate. Conclusively, that the physical and mechanical properties are affected by the blend ratios.

Keywords: Jackfruit seed, sago starch, biodegradable plastic, mechanical properties, physical properties, degradability properties.

Graphical Abstract
[1]
Rosa D dos S, Bardi M, Machado L, Dias D. L. A. e Silva, and Y. Kodama, “Influence of thermoplastic starch plasticized with biodiesel glycerol on thermal properties of pp blends. J Therm Anal Calorim 2009; 97(2): 565-70..
[http://dx.doi.org/10.1007/s10973-009-0120-6]
[2]
Fischer S, de Vlieger J, Kock T, Batenburg L, Fischer H. ‘Green’ nano-composite materials - new possibilities for bioplastics1 MRS Proc. vol. 661.
[3]
Reddy MM, Mohanty AK, Misra M. Optimization of tensile properties thermoplastic blends from soy and biodegradable polyesters: Taguchi design of experiments approach. J Mater Sci 2012; 47(6): 2591-9.
[http://dx.doi.org/10.1007/s10853-011-6083-6]
[4]
Jagadeesh D, Jeevan Prasad Reddy D, Varada Rajulu A. Preparation and properties of biodegradable films from wheat protein isolate. J Polym Environ 2011; 19(1): 248-53.
[http://dx.doi.org/10.1007/s10924-010-0271-3]
[5]
Li M, et al. Extrusion processing and characterization of edible starch films with different amylose contents. J Food Eng 2011; 106(1): 95-101.
[http://dx.doi.org/10.1016/j.jfoodeng.2011.04.021]
[6]
Mali S, Grossmann MVE, Garcia MA, Martino MN, Zaritzky NE. Microstructural characterization of yam starch films. Carbohydr Polym 2002; 50(4): 379-86.
[http://dx.doi.org/10.1016/S0144-8617(02)00058-9]
[7]
Wang K, Wang W, Ye R, et al. Mechanical and barrier properties of maize starch-gelatin composite films: effects of amylose content. J Sci Food Agric 2017; 97(11): 3613-22.
[http://dx.doi.org/10.1002/jsfa.8220 PMID: 28102016]
[8]
Kane SN, Mishra A, Dutta AK. Utilization starch of jackfruit seed (Artocarpus heterophyllus) as raw material for bioplastics manufacturing using sorbitol as plasticizer and chitosan as filler. J Phys Conf Ser 2016; 755(1)
[9]
Madruga MS, de Albuquerque FSM, Silva IRA, do Amaral DS, Magnani M, Queiroga Neto V. Chemical, morphological and functional properties of Brazilian jackfruit (Artocarpus heterophyllus L.) seeds starch. Food Chem 2014; 143: 440-5.
[http://dx.doi.org/10.1016/j.foodchem.2013.08.003 PMID: 24054264]
[10]
Lothfy FA, Haron MF, Rafaie HA. Fabrication and characterization of jackfruit seed powder and polyvinyl alcohol blend as biodegradable plastic. 2018.vol. 3: pp. (no. 2)1-5..
[11]
Bates RERFL, French D. Amylose and Amylopectin Content of Starches Determined by their Iodine Complex Formation. J Am Chem Soc 1943; 65(2): 142-8.
[http://dx.doi.org/10.1021/ja01242a003]
[12]
Ismail H, Zaaba NF. Tensile properties, degradation behavior, and water absorption of sago starch plastic films. J Vinyl Addit Technol 2012; 18(4): 235-40.
[http://dx.doi.org/10.1002/vnl.20300]
[13]
Obasi HC, Igwe IO, Madufor IC. “Effect of soil burial on tensile properties of polypropylene/plasticized cassava starch blends,” Adv. inMaterials Sci. Eng 2013; 2013: 2-5.
[14]
Alves VD, Mali S, Beléia A, Grossmann MVE. Effect of glycerol and amylose enrichment on cassava starch film properties. J Food Eng 2007; 78(3): 941-6.
[http://dx.doi.org/10.1016/j.jfoodeng.2005.12.007]
[15]
Wittaya T. Agricultural and Biological Sciences. Structure and Function of Food Engineering 2012.
[16]
Liestianty DI. Rodianawati, Patimah, and Muliadi. Chemical composition of modified and fortified sago starch (Metroxylonsp) from Northern Maluku. Int J Appl Chem 2016; 12(3): 243-9.
[17]
Kaplan DL. Biopolymer from renewable resources. Springer 1998.
[http://dx.doi.org/10.1007/978-3-662-03680-8]
[18]
Piyada K, Waranyou S, Thawien W. Mechanical, thermal and structural properties of rice starch films reinforced with rice starch nanocrystals. Int Food Res J 2013; 20(1): 439-49.
[19]
Edhirej A, Sapuan SM, Jawaid M, Zahari NI. Cassava/sugar palm fiber reinforced cassava starch hybrid composites: Physical, thermal and structural properties. Int J Biol Macromol 2017; 101: 75-83.
[http://dx.doi.org/10.1016/j.ijbiomac.2017.03.045 PMID: 28288881]
[20]
Abral H. A simple method for improving the properties of the sago starch films prepared by using ultrasonication treatment. Food Hydrocoll 2019; 93: 276-83.
[http://dx.doi.org/10.1016/j.foodhyd.2019.02.012]
[21]
Rahmah M, Muizz Fahimi M, Afiqah Juhari F, Mawardi Rahmat A, Aishah S, Isa M. FTIR characterization and strength performance of degradable additive incorporated polyethylene terephthelate (PET) bottle upon exposure to different environment. 2016; vol. 4: pp. 2321-9009..
[22]
Imam SH, Cinelli P, Gordon SH, Chiellini E. Characterization of biodegradable composite films prepared from blends of poly(vinyl alcohol), cornstarch, and lignocellulosic fiber. J Polym Environ 2005; 13(1): 47-55.
[http://dx.doi.org/10.1007/s10924-004-1215-6]

Rights & Permissions Print Cite
© 2024 Bentham Science Publishers | Privacy Policy